Bosch Appliances VG4-500I, VG4-200 Setting the Camera Address, Keyboard Commands, FastAddress

4 en Getting Started AutoDome Modular Camera System

1.2.2Keyboard Commands

Keyboard control commands are composed of a sequence of three (3) inputs with the follow- ing convention: 1) a Function key + 2) a Command number key(s) + 3) the Enter key.

–Depending on the type of keyboard, the control function keys are labeled: ON or AUX ON

OFF or AUX OFF SET or SET SHOT SHOT or SHOW SHOT

i	NOTICE! The convention used for control key commands in this manual is ON, OFF, SET, and
	SHOT. Refer to your keyboard manual for the key naming conventions.

–Command numbers range from 1 to 999. See Chapter 6: Keyboard Commands by Number for a complete list of keyboard commands.

–The Enter key can also be labeled with the  symbol.

	For example, the keyboard command to make the AutoDome pan 360º continuously is:
	ON-1-ENTER
	Press the ON key, then press the number 1 key, and then press ENTER.
1.3	Setting the Camera Address
	Once the AutoDome power is turned on and homing is complete, you must set the camera
	address. You may also want to assign a password and customize some of the AutoDome
	default settings.
i	NOTICE! You do not need to set a camera address if using Bilinx or Ethernet communication.
	See the AutoDome Installation Manual to configure an AutoDome for Bilinx or Ethernet
	operation.
1.3.1	FastAddress
	FastAddress is an AutoDome feature that allows you to set or change a camera address using
	the keyboard and on-screen menus.
	There are three (3) FastAddress commands:
	– ON-999-ENTER: Displays and programs all cameras without an address in the system.
i	NOTICE! If a keyboard is set to a camera number that already has an address, that camera also
	responds to this command.

–ON-998-ENTER: Displays and programs all cameras with or without an address in the sys- tem.

–ON-997-ENTER: Displays the current address status of all cameras in the system simulta- neously.

To set an address to a camera without an address:

1.Select the camera number you want to FastAddress. The system displays the camera number on the keyboard and the image on the corresponding monitor.

2.Press #-ENTER(where # is the camera number without an address).

3.Press ON-999-ENTERto invoke an on-screen display of cameras on the system without an address.

F01U064036 1.0 2007.01 VG4-200, VG4-300, VG4-500i Series User’s Manual Bosch Security Systems, Inc.