Bosch Power Tools 1619EVS manual Operation in Router Table, Attaching Router to Mounting Plate

BM 2610933969 09-12_BM 2610933969 09-12.qxp 9/20/12 9:19 AM Page 19

Operation in Router Table

! WARNING	For safe operation, read and understand this router manual and the router
	table’s manual before using either.

ATTACHING ROUTER TO MOUNTING PLATE

1.Remove the router sub-base.

2.The router is now ready for mounting to a router table. Install router to mounting plate and router table according to the instructions provided with that accessory.

3.Attach the base to your router table using four 1/4"-20 x 1-1/2" Phillips machine screws, washers and nuts. The length will depend on the thickness of your router table or router table mounting plate.

ADjUSTING THE DEPTH

1.Install the desired bit.

2.Lift router motor to approximate desired height and lock coarse adjust lock.

3.When used in the router table, most depth-of- cut adjustments will be made with the fine adjustment knob. For easier under-table height adjustment, press the optional fine adjustment knob extension onto the end of the fine adjustment knob. (Fig. 25)

FIG. 25

CONNECT THE ROUTER AND THE ROUTER

TABLE SWITCH

To prepare for use of the switch,

1.Make sure the router switch and the router table switch are both turned off.

2.Plug the router table switch cord to wall outlet.

3.Plug the router into the "pigtail" socket on the router table switch.

4.Lock router switch on: squeeze trigger, depress lock-on button, and release trigger.

5.Use the router table switch to start and stop the router.

FEEDING THE WORKPIECE ON

A ROUTER TABLE

Always use your router table's fence or starter pin and the appropriate guard and follow the router table's instruction manual. ALWAYS feed the workpiece from right to left across the front of the bit. On Bosch router tables, the correct feed direction is also shown on fence housing and on the featherboards, when they have been properly installed. (Fig. 26)

Whenever possible, when using the fence, use a push stick to push the workpiece, especially when working with narrow pieces.

FIG. 26

DIRECTION

OF FEED

FENCE FACE FENCE FACE

WORKPIECE

BIT

BEARING

TOP VIEW

NOTE: For clarity, guard and featherboard removed from drawing.

RESTORING THE ROUTER TO NORMAL

UPRIGHT (HAND-HELD) PLUNGE

OPERATION

1.Remove the router from the table and bring it back to its normal upright position.

2.Remove the bit and collet chuck.

3.Remove the router table mounting plate and reattach the router’s sub-base.

4.While supporting the router with one hand, release the coarse adjust lock by turning it to the left. Then lower the motor until it comes to a rest.

5.Reactivate the plunge return spring by pressing the router motor further down. The router will automatically pop up from its own spring pressure.

6.Release the depth rod from to keyhole in the depth stop turret. (The rod needs to be moved downward slightly in order to clear the small circular recess on the underside of the smaller end of the keyhole.)

-19-