Bosch Power Tools 1619EVS manual Operating Instructions, Router Dust Collection, Plunging Action

BM 2610933969 09-12_BM 2610933969 09-12.qxp 9/20/12 9:19 AM Page 10

ROUTER DUST COLLECTION

Your router is equipped with a dust extraction hood. If you have a shop vacuum system, you can attach the dust extraction hood for improved visibility, accuracy and utility, particularly in freehand routing.

To attach, align tabs on hood with notches in base, and position as shown. Rotate hood slightly counter-clockwise and secure adapter to base with the thumbscrew provided (Fig. 5).

To further enhance the dust collection efficiency, insert the extraction enhancement ring. To remove, press the two tabs inward, and lift out. Make sure ring does not touch bit at any time.

The dust extraction hood itself is sized to accept 35mm vacuum hoses. Also included is an adapter that will connect the hood to 1-1/4” and 1-1/2” vacuum hoses.

FIG. 5	ExTRACTION
	ENHANCEMENT
	RING

DUST THUMB

ExTRACTIONSCREW HOOD

Also available as an optional accessory is a special dust collection for edge forming. Do not use both hoods at the same time.

INSTALLING TEMPLET GUIDE ADAPTER

Place templet guide adapter over the holes in the center of the sub-base, and align the two threaded holes in the bottom of adapter with the countersunk holes in sub-base. Fasten adapter with the screws provided. Note that the adapter is reversible, so the release lever may be positioned as desired (Fig. 6).

TEMPLET GUIDE

ADAPTER

TEMPLET GUIDE

RELEASE

LEVER

FIG. 6

MOUNTING SCREWS

Operating Instructions

Bosch plunge routers are designed for speed,	FIG. 7
accuracy and convenience in performing
cabinet work, routing, fluting, beading, cove-
cutting, dovetails, etc. This will enable you to
accomplish inlay work, decorative edges and
many types of special carving.
PLUNGING ACTION
The plunge feature simplifies depth adjustments
and will allow the cutting bit to easily and
accurately enter the workpiece. To lower, push
plunge lock lever to the left, apply downward
pressure until you reach desired depth, and
release pressure on lever to lock (Fig. 7). The
plunge lock lever is spring loaded and returns
automatically to the locked position. To raise
the router, push plunge lock lever to the left,
release pressure on router and the router will
automatically retract the bit from the workpiece.
It is advisable to retract the bit whenever it is not
engaged in workpiece.

PLUNGE

LOCK

LEVER

-10-