54
Basic Saw Operations
Detent Override
To Engage:
1. Lift the miter detent trigger 1(Figure 24).
2. Push the detent override clip 2 forward and latch in place
over edge. Release miter detent trigger 1.
3. Move miter arm 3to any position on the miter scale.
4. Lock the miter lock knob 4to retain miter position.
To Disengage:
5. Loosen miter lock knob 4and lift the miter detent trigger
1to release the detent override clip 2.
Sliding Base/Fence Extension
Extend and use sliding base/fence when
making severe bevel, severe miter or
compound cuts to provide sufficient (minimum 6”) spacing
from hand to saw blade.
Sliding Base:
1. Remove hex wrench from storage position on left rear
leg.
2. Loosen two (2) socket cap screws 5in sliding base
channel with the 6 mm hex wrench provided (Figure 25).
3. Extend sliding base/fence 6to the desired position.
4. Tighten screws. Store hex wrench.
Sliding Fence:
1. Unlock the fence locking lever 7(Figure 26).
2. Slide fence to proper position 8.
3. Relock fence in place.
During transportation, sliding base and
fence should always be secured in the full
in position.
50
45
40
FIG. 24
FIG. 25
1
2
4
3
5
6
FIG. 26
7
8
WARNIN
G
!
CAUTION
!