14
Quick Start

Making the Connections

1. Make sure of the following for all the equipment you will be connecting.
• The power is turned off.
• The volume is turned down.
2. Connect the AC adaptor (BRC series) to the AC adaptor jack, and plug it into an AC outlet.
fig.00-01
* Use only the BRC series. If you use any other AC adaptor, you risk causing malfunction
and/or damage.
* To prevent the inadvertent disruption of power to your unit (should the plug be pulled
out accidentally), and to avoid applying undue stress to the AC adaptor jack, anchor the
power cord using the cord hook, as shown in the illustration.
3. Connect the audio cables and MIDI cables as shown in the diagram.
fig.00-02
\fig.00-03
* To prevent malfunction and/or damage to speakers or other devices, always turn down
the volume, and turn off the power on all devices before making any connections.
* If you connect a foot switch (FS-5; sold separately) to the FOOT SW jack, set the polarity
switch as shown below.
* Howling could be produced depending on the location of microphones relative to speakers.
This can be remedied by:
1. Changing the orientation of the microphone(s).
2. Relocating microphone(s) at a greater distance from speakers.
3. Lowering volume levels.
MIDI
Sequencer
etc.
SP-303 etc.
CD/MD player etc.
CD/MD player etc.
Stereo
Headphones
Microphone
OUTPUT
MIDI cable
Audio Set / Amplified Speaker etc.
LINE IN
Audio Cable
Foot Switch
(FS-5U etc.)
AC Adaptor
(BRC-series)
Polarity Switch