43
Chapter 3. Recording samples
3
Resampling procedure 2 (Manual)1. Press [RESAMPLE] to make the button light.
[SAMPLING] will blink, and the SP-505 will be in
standby mode.
At this time, pads to which no sample has been assigned
will blink.
* If samples are assigned to all pads in the currently selected pad
bank, no pad will blink. Please switch pad banks. (p. 30)
Never turn off the power while the display indicates
“Keep Power On!”
* If you want to cancel resampling at this point, press [EXIT].
2. Press the pad to which you want to assign the
resampled sound (sample).
* If a sample is already assigned to the selected pad, the display
will ask “OK to Overwrite?” If you want to use that pad,
press [F1] (YES). To cancel, press [F2] (NO).
3. Make settings for resampling. (Refer to p. 39–40)
The remaining time available for sampling is shown in
the top line (REMAIN).
Type
MONO: Monaural recording
STEREO: Stereo recording
Grade
STANDARD
: High-quality sampling
LONG: Extended-length sampling
LO-FI: Lo-fi sampling
Auto
In this case, turn this OFF.
OFF: Manually start/end resampling.
ON: When you select the pad from which resampling
will be performed (the Source Pad) and start
resampling, the source pad will automatically
begin playing, and resampling will end when the
source pad finishes playing.
4. Press [SAMPLING].
fig.03-07
5. As necessary, switch the pad bank (p. 30), and press the
pad(s) for the sample(s) that you want to resample (the
Source Pads).
The source pad will begin playing, and resampling will
start.
[EXT SOURCE] can also be specified as the source pad.
fig.03-08
* It is not possible to switch pad banks during resampling.
6. When you are finished resampling, press
[SAMPLING].