Install Tension Shaft | Bowflex 001-7057 specification

Assembly

17

Step 12 Install Tension Shaft

Parts:

• Main Unit

• Shaft (Box 3)

Main unit

Rounded edge on top

12-1Align the rounded side of the Tension Shaft with the rounded side of the hole in the Main Unit and slowly slide the Shaft through until it clicks into place.

If the Shaft is obstructed inside the Main Unit, loosen the tension screws in the Tension Shaft Holder (see Step 13).

Shaft

Note: If you didn’t feel or hear a distinct click, make sure the shaft is centered by measuring the amount of exposed shaft on each side of the Main Unit. There should be an equal measure on each side.

Image 17

Bowflex 001-7057 manual Install Tension Shaft

Contents

Home Gym Before You Start Table of Contents Hardware Card Box Tools You Will Need Hardware Hardware Hardware Card Box Box 1 Contents Box Contents Box 2 Contents Box 3 Contents Box 4 Contents Step Assembly Unboxing Rubber Pads Box 3 hardware card Assemble Rear Stabilizer Install Rear Stabilizer Hardware Install Stabilizers and Lower Lat Connector Step Separate styrofoam Packing Lift box Styrofoam packing Remove Styrofoam Inner Packing AssemblyRemove Top Cover Install Tension Shaft Tighten Tension Shaft Holder Remove Cam Holders Install Pre-Tension SpiraFlex Packs Replace Top Cover Adjusting Cable Tension Install Seat Support Plates Assembly Adjusting Cable Tension Seat Tube Cap Install Seat Tube Rope Hooks Box 3 Hardware Card Install Cable Hooks Figure a Install Pulleys Install Seat Pad Install Back Pad Attaching Seat and Back Pad End Caps Box 4 Hardware Card Assemble Leg Extension Figure a Cable Install Cables Apply Revolution XP Decal Final Inspection Important Contact Numbers For assistance