Step 21 Install Pulleys
Parts:
• Pulley Components (Box 3)
Tools:
• Screwdriver
Pulley
Hook Bolt
Spring
Spring Cap
Hook Bolt
Spring Cap
![](/images/new-backgrounds/1246338/24633847xi3.webp)
![](/images/new-backgrounds/1246338/24633847xi4.webp)
![](/images/new-backgrounds/1246338/24633847xi5.webp)
Hex Nut (discard)
NOTE: Remove and discard the hex nut to disassemble the Pulley components.
21-1Place a Spring Cap over a threaded hole in a Stabilizer and screw the Hook Bolt into the hole ONLY about three turns. (Figure A)
21-2Place the Spring down over the Hook Bolt. Compress the Spring and hook the Eyelet under the Pulley to the Hook Bolt. (Figure B)
21-3Place a screwdriver through the Spring and Hook Bolt on the Pulleys and tightly screw them into the Stabilizers. (Figure C) ![](/images/new-backgrounds/1246338/24633847xi7.webp)
NOTE: Place the pulleys with the
pre-installed cable closest to the main frame.
Pulley |
Hook Bolt |
Eyelet |
Spring |
Figure B
Figure C