Bowflex 001-7057 manual Adjusting Cable Tension, Replace Top Cover

20

Assembly

Step 16 Replace Top Cover

Parts:

• Top Cover

Tools:

• 1/8” Allen Wrench

Make sure inside edges	Allen Screw	Top Cover
of Shroud fit in slots
on Top Cover		Rear
	Slots
Front
	Inside Edge	Tab
		Shroud

16-1If the screws are still in the Top Cover from Step 1, remove them to avoid dropping them into the Main Unit.

16-2Replace the Top Cover front end first. Make sure inside edge of the Shroud fits into the slots in the Top Cover. Now seat the rear making sure the tabs on the Top Cover fit inside the Shroud.

16-3Install and completely tighten the hardware.

! 4 4 % . 4 ) / .

Before Installing the Seat Support Plates (Step 17), make sure the Cables are properly tensioned according to the following procedure . If there is slack in the Cables, the Support Plate Bolts could cause interference.

Adjusting Cable Tension

Pay close attention to maintenance of the cable tension. Over time and with heavy use, the cables are designed to give slightly. Located on the main engine housing is a tension control knob which allows you to increase the tension in the cables.

Checking for incorrect cable tension is simple.

1.Position the adjustable swing arms in the upper most position.

2.Check to see if clips at end of cable hang down or if they are tight against the pulley.

3.If cables don’t have enough tension, use the tension control knob on the side of the machine to tighten the cables. (See image).

4.To increase tension, pull tension knob outward and turn the large pulley clockwise. The clip on the cable should be touching the pulley.