Removing the Batteries from Wheelchair | Invacare SP guide

SECTION 10—BATTERIES

Removing the Batteries from Wheelchair

NOTE: For this procedure, refer to FIGURE 10.3 on page 59.

1.Slide battery tray with batteries out.

2.Disconnect the battery straps.

3.Unplug front battery from rear battery.

4.Remove the front battery.

5.Slide the rear battery forward and remove it from the tray.

	FRONT OF	NOTE: 22NF Batteries
	FRONT OF	shown.
	WHEELCHAIR	shown.
		Rear Battery
		Disconnect Front Battery
		from Rear Battery Here
		Front Battery
NOTE: Battery tray		Battery Straps
shown removed for
clarity.	Battery Tray

FIGURE 10.3 Removing the Batteries from Wheelchair

Installing Batteries into Wheelchair

NOTE: For this procedure, refer to FIGURE 10.3 and FIGURE 10.4 on page 60.

NOTE: Positioning of the batteries into the battery tray is completed with battery tray positioned in wheelchair and partially pulled out. Refer to FIGURE 10.3 for full view of wheelchair base. Illustrations in FIGURE 10.4 on page 60 are shown without the wheelchair for clarification purposes only.

1.Position the battery with battery connector bracket in the rear of the battery tray in the orientation as shown. See Detail “A” of FIGURE 10.4 on page 60.

NOTE: Front of battery tray is designated by the battery stop. Rear of the battery tray is the opposite end.

NOTE: Orientation of the battery is critical otherwise batteries will not connect to the controller or each other.

2.Position the remaining battery in the front of the battery tray in the orientation shown so that the wiring harnesses can be connected together. See Detail “B” of FIGURE 10.4 on page 60.

3.Connect front battery to rear battery. See Detail “B” of FIGURE 10.4 on page 60.

4.Connect battery straps. See Detail “C” of FIGURE 10.4 on page 60.

Part No 1143190

59

TDX™ SP

Image 59

Invacare SP manual Removing the Batteries from Wheelchair, Installing Batteries into Wheelchair

Contents

TDX SP Manual Reference DocumentsReference Documents Table of Contents Safety INSPECTION/TROUBLESHOOTING Motor Locks Complete and mail the form on the next Register Your Product City State/Province Product Registration Form Fold here Cut Along Line Meaning Special NotesSpecial Notes Trro and Trbkts Warnings Label Locations Label LocationsAll Wheelchairs Wheelchairs with 22NF Batteries Wheelchairs with GP24 Batteries Wheelchairs with Trro Wheelchairs without Trro Typical Product Parameters Typical Product Parameters General Guidelines Repair or Service InformationGeneral Guidelines Operation Information Wheelchairs with Trro or Trbkts Only Tire Pressure Charging Batteries ElectricalBatteries Grounding Instructions Rain Test Weight TrainingWeight Limitation EMI Information EMI Information EMI Information Stability and Balance SAFETY/HANDLING of WheelchairsSAFETY/HANDLING of Wheelchairs Coping with Everyday Obstacles Coping with Everyday Obstacles Reaching, Leaning and Bending Reaching, Leaning and Bending Forward Pinch Points Reaching, Bending Backward Stairways Transferring To and From Other Seats Transferring To and From Other Seats Safety INSPECTION/TROUBLESHOOTING Safety INSPECTION/ TroubleshootingSafety Inspection Checklists Inspect/Adjust Initially Inspect/Adjust Monthly Inspect/Adjust Weekly Inspect/Adjust Every 2 Years Troubleshooting MechanicalInspect/Adjust Periodically Inspect/Adjust Every 18 Months Display Description Definition Troubleshooting ElectricalInformation Gauge Display Diagnostics SPJ+, SPJ+ w/PSS or SPJ+ w/ACC Joysticks MPJ+, PSR+, PSF+ Joysticks or Displays Service Indicator Light DiagnosticsPossible Solution Symptom Probable Cause Solutions BAD Joystick CAL Values DON’T Checking Battery Charge Level Operating the Wheelchair Turning the Power On/OffUsing the Joystick to Drive the Wheelchair Wheelchair Operation Wheelchair Movement Action Speedometer On/Off Button Charger/Programming Input Service IndicatorSpeed Control Buttons Joystick Information Gauge Display MPJ+ Joystick Switches and IndicatorsDrive Select Toggle Switch Selecting the Drive Mode LCD Display Screens Speed Control Main Screen Splash Screen Wheelchair Operation Description Status Indicator Connected Devices Screen Programmable Mono Port 1/2 or External Mode SwitchRemote Stop Switch Remote Mode Reset Switch Memory Card Slot Remote On/Off SwitchMode Switch Van Seats Repositioning Joystick Connecting Disconnecting/Connecting the JoysticksAdjustable Asba Seats Disconnecting MPJ+ Joysticks 11 Disconnecting/Connecting Joysticks SPJ+ Joysticks Motor Locks Motor LocksDisengaging/Engaging Motor Lock Levers Disengaging Wheel LocksDisengaging/Engaging the Wheel locks Engaging Pinch point may occur when rotating the footboard assembly Footboard AssemblyRemoving/Installing the Footboard Installing Removing/Installing the Footboard Adjusting the Footboard Angle Forks Adjusting ForksForks Batteries Batteries For TDX SP Wheelchairs Using 22NF Batteries Using the Proper Batteries Replacing Batteries Wire Cutter Replacing Batteries Removing/Installing the Batteries From/Into the Wheelchair Cleaning Battery Terminals Battery Retention Bracket Removing the Batteries from Wheelchair Installing Batteries into Wheelchair Installing Batteries into Wheelchair MPJ+ Joystick When to Charge BatteriesSPJ+, SPJ+ w/PSS and SPJ+ w/ACC Joysticks Charging Batteries Description and Use of Battery Chargers Tool Quantity Required Items Transport Ready Package Trro Transport Ready Package Trro Compliance Information About Transport Ready Packages Positioning the Wheelchair in the Vehicle SpecificationsMotor Wheelchair Weight Limit Adult Securing the Wheelchair to the Vehicle Securing the Wheelchair Securement Points Wheelchair-Anchored Belts Securing the Occupant Wheelchair-Anchored Belts Seating System Vehicle-Anchored Belts Positioning Belts Positioning Belts USA Limited Warranty