Invacare SP manual Disconnecting/Connecting the Joysticks, NOTE For this procedure, refer to

SECTION 5—WHEELCHAIR OPERATION

Adjustable ASBA Seats

NOTE: For this procedure, refer to

FIGURE 5.10.

1.	Turn the adjustment lock lever to
	release the joystick mounting tube from
	the mounting bracket.
2.	Remove the joystick from the wheelchair.
3.	Remove the three hex screws that
	secure both halves of the mounting
	bracket to the arm tube.
4.	Reposition mounting bracket on

Mounting Bracket

Mounting(Threaded Plate)

Bracket

Washers

	Arm Tube
Adjustment	NOTE:
Lock Lever	Joystick
	not shown.

Hex Mounting

opposite arm tube ensuring the

threaded plate of the mounting bracket

Screws

Joystick Mounting Tube

is on the inside of the arm tube as

shown in FIGURE 5.10.

FIGURE 5.10 Repositioning Joystick -

Adjustable ASBA Seats

5.Using the three hex mounting screws and washers, secure both halves of the mounting bracket to the arm tube.

6.Slide the joystick mounting tube through the mounting bracket to the desired position.

7.Turn the adjustment lock lever to secure the joystick mounting tube into the mounting bracket.

Disconnecting/Connecting the Joysticks

NOTE: For this procedure, refer to FIGURE 5.11 on page 47.

NOTE: The joystick connector is located at the rear of the seat frame.

SPJ+ Joysticks

Disconnecting

1.Loosen the thumb screws on the joystick connector.

2.Disconnect the joystick connector from the controller connector.

Connecting

1.Align the joystick connector with the controller connector.

2.Secure the joystick connector to the controller connector using the thumb screws on the controller connector.

TDX™ SP 46 Part No 1143190