Bradford-White Corp 238-42498-00J REV 10/06, Direct Vent Gas Water Heater General Operation

Internet Version for Reference Only

GENERAL OPERATION

WARNING

Water heaters are heat-producing appliances. To avoid damage or injury, do not store materials against the water heater or vent-air intake system. Use proper care to avoid unnecessary contact (especially by children) with the water heater and vent-air intake system. UNDER NO

CIRCUMSTANCES SHALL FLAMMABLE MATERIALS, SUCH AS

GASOLINE OR PAINT THINNER BE USED OR STORED IN THE

VICINITY OF THIS WATER HEATER, VENT-AIR INTAKE SYSTEM OR

IN ANY LOCATION FROM WHICH FUMES COULD REACH THE

WATER HEATER OR VENT-AIR INTAKE SYSTEM.

TO FILL THE WATER HEATER

1. Close the water heater drain valve by turning the knob clockwise .

2. Open the cold water supply shut-off valve.

3. Open several hot water faucets to allow air to escape from the system.

4. When a steady stream of water flows from the faucets, the water heater is filled. Close the faucets and check for water leaks at the water heater drain valve, combination temperature and pressure relief valve and the hot and cold water connections.

TO DRAIN THE WATER HEATER

Should it become necessary to completely drain the water heater, make sure you follow the steps below:

1.	Set the thermostat dial to the lowest possible position.
2.	Rotate and if applicable partially depress gas control knob clockwise
	to the “OFF” position.
3.	Shut off the gas supply to the water heater.
4.	Close the cold water supply shut-off valve.
5.	Open the drain valve on the water heater by turning the knob counter-
	clockwise	. The drain valve has threads on the end that will allow
	the connection of a standard hose coupling.
6.	Open a hot water faucet to allow air to enter the system.

To refill the water heater, refer to “To Fill the Water Heater.”

30