Bradley Smoker Valve and tubing connections, TDB3108, WF3208 Terreon 54 Circular, Installation

TDB3108, WF3208 Terreon® 54" Circular Installation

5

Valve and tubing connections

NOTE: Flush supply lines before making connections. Do not apply pipe sealant to compression fittings.

CONNECT 1/2" DIA. TUBING TO TEE AND SOLENOID ASSEMBLY, TWO PLACES. THE MALE CONNECTOR

A (FIGURE 10B) FOR THE VALVE ASSEMBLY WILL REMAIN TIGHT AND LEAKPROOF WHEN TUBING IS CUT AND INSTALLED PROPERLY. FOLLOW THE PROCEDURES BELOW WHEN INSTALLING TUBING TO ENSURE THAT YOU ACHIEVE A LEAKPROOF SEAL.

•USING A SHARP RAZOR, CUT TUBING SQUARELY AND REMOVE ANY BURRS. DO NOT PINCH OR CRUSH END OF TUBING.

•LOOSEN NUT ON FITTING. MOISTEN END OF TUBE AND PUSH INTO FITTING UNTIL IT IS FIRMLY SEATED. TIGHTEN NUT TO SECURE TUBE TO FITTING (MAKE SURE NUT IS SECURELY TIGHTENED).

•IF CONNECTOR LEAKS, RESEAT TUBING ACCORDING TO ABOVE PROCEDURE. IF LEAKING PERSISTS, REPLACE MALE CONNECTOR, OR CALL YOUR BRADLEY REPRESENTATIVE FOR ASSISTANCE.

B HANG VALVE ASSEMBLY ON PEDESTAL BRACKET (SEE FIGURE 11 ON PAGE 17). USE WIRE TIE TO SECURE VALVES.

NOTE! For “O” and “B” units (overhead supplies) Skip steps C through E

C CONNECT THE 1/2" NPT FEMALE END OF THE STOP/CHECK VALVES TO THE ROUGH-INS.
D ATTACH FLEXIBLE HOSING TO THERMOSTATIC MIXING VALVE, TWO PLACES.
E	INSERT THE FILTER WASHERS (PROVIDED) INTO THE SWIVEL NUT AT THE END OF THE SUPPLY HOSES AND CONNECT TO THE
	STOP/CHECK VALVES.

1/2" DIA. TUBE
FROM SPRAYHEAD
	TEE
	269-764
1/2" DIA. TUBE		NUT
R68-600012	VOLUME CONTROL
	S02-045
SOLENOID
ASSY.		TUBING
S08-055
		MALE TUBE
FLEXIBLE		CONNECTOR
HOSE
FILTER WASHER	THERMOSTATIC
	MIXING VALVE
	ASSEMBLY
	S67-597
STOP/CHECK
VALVE
Figure 10a	VALVE ASSEMBLY S50-369	Figure 10b
16	4/6/2007	Bradley Corporation • 215-1187 Rev. N; EN 06-915B