Bradley Smoker TDB3108 Electrical connections for Adaptive Infrared, Installation, 4/6/2007

TDB3108, WF3208 Terreon® 54" Circular Installation

6

Electrical connections for Adaptive Infrared

START-UP NOTE: Do not use for two minutes after making power connection. The sensors will take up to eight minutes (without being used) to adapt to the bowl if another object is detected during the two-minute start-up period.

CONNECT THE THREE WIRES FROM THE INFRARED MODULE ASSEMBLY TO THE VALVE ASSEMBLY. ATTACH TWO OF THE FEMALE A CONNECT WIRES TO THE SOLENOIDS AS SHOWN IN FIGURE 12. ATTACH THE MALE CONNECT WIRE TO ONE OF THE 24 VAC

TRANSFORMER LEADS. ATTACH THE REMAINING TRANSFORMER LEAD TO THE SOLENOID WIRE ADAPTER (SEE FIGURE 12).

B CONNECT 24 VAC TRANSFORMER PROVIDED TO POWER SOURCE.

C TURN SUPPLIES ON. OPEN CHECK/STOP VALVES COMPLETELY.

D OPEN VOLUME CONTROL VALVE COMPLETELY AND CHECK PIPING INSTALLATION FOR LEAKS.

E PASS YOUR HAND IN FRONT OF EACH SENSOR UNTIL AIR IS PURGED FROM THE LINES.

I.R. MODULE

S50-344

WINDOW 269-1351

(S53-272) B	(S53-261A) A	TOP VIEW MODULE
	RED	ASSEMBLY
BLACK		CONNECT WIRES
		AS SHOWN

(S53-261A) C

RED

VALVE ASSY.

S50-369

110/24 VAC TRANSFORMER S83-134

WIRE
ADAPTER
269-620	S53-261	F = FEMALE CONNECT
Figure 12		M = MALE CONNECT

18 4/6/2007 Bradley Corporation • 215-1187 Rev. N; EN 06-915B