Bradley Smoker TDB3108 Supplies Required by Installer, Table of Contents, Terreon Material

TDB3108, WF3208 Terreon® 54" Circular	Installation
Table of Contents
Pre-Installation Information	. . . .2
Model TDB3108 Dimensions	. . 3-5
Model WF3208 Dimensions	. . . .6
Washfountain Rough-Ins	. . 7-8
Installation Information	.9-19
Terreon® Cleaning/Maintenance	. . .20
Gel-Coated Fiberglass Cleaning/Maintenance	. . .20
Stainless Steel Cleaning/Maintenance	. . .21
Soap Dispensing Valve Repair Parts	22-23
Soap Recommendations and Maintenance	. . .24
Sprayhead Troubleshooting/Repair Parts	. . 25
Manual Mixing Valve (optional)	. . .26
Volume Control Valve	. . .27
Vernatherm™ Thermostatic Mixing Valve	28-29

Supplies Required by Installer

•(4) 1/2" lag bolts, screws or other fasteners to anchor washfountain pedestal

•1" hot and cold water supply lines and fittings (refer to rough-ins on pages 7-8)

•Reducing fittings and 1/2" nom. copper tubing supply lines for types with supplies from above

•Standard P-trap (refer to rough-ins on pages 7-8) (vented trap supplied by Bradley when required)

•2" drain lines and fittings (refer to rough-ins on pages 7-8)

•1-1/2" vent or tie pipe on fixtures vented through washfountain column (see page 9 for lengths required)

•Teflon tape or pipe dope

•110 VAC GFI power source for 110/24 VAC UL Class II transformer supplied

•OPTIONAL: Bradley recommends installing an electrical cut-off switch to the unit. This feature allows no accidental water delivery during regular maintenance and service.

Pre-Installation Information

Terreon® Material

The Washfountain is constructed of Terreon®, a densified solid surface material composed of polyester resin. Terreon® is resistant to chemicals, stains, burns and impact. Surface damage can be easily repaired with everyday cleaners or fine-grit abrasives. Terreon® is NAHB certified to meet ANSI Z124.3, Z124.6 and ANSI/ICPA SS-1-2001.

Adaptive Infrared

The sprayhead is controlled by a solenoid valve, allowing the user to activate a flow of water. The Infrared sensor will take a few minutes to adapt to its environment when the unit is powered up.

2 4/6/2007 Bradley Corporation • 215-1187 Rev. N; EN 06-915B