AdjustmentsToggle Positioning

Both toggles should be positioned so that they provide even pressure on the media. The toggles are positioned by sliding them to the desired location. On media too narrow to accommodate both toggles, position one toggle over the center of the media and decrease the pressure on the unused toggle. If you are using a 300X-PLUSor 600X-PLUSprinter, position the toggle over the center of the media.

NOTE: Make sure that the toggle pressure is even across the width of the

media. Otherwise, the media and/or ribbon may “drift.”

Label

available

sensors

Adjusting

nuts

Figure 32

72

Brady X-PLUSSeries User’s Guide