Leaving the Setup Mode

You can leave the program mode at any time by pressing the SETUP/EXIT key. The “SAVE CHANGES” display will appear. There are five choices, described below. Pressing the LEFT or RIGHT BLACK OVAL key displays other choices and pressing the NEXT/SAVE key selects the displayed choice.

νPERMANENT - Permanently saves the changes. Values are stored in the printer even when power is turned off.

νTEMPORARY - Saves the changes until changed again or until power is turned off.

νCANCEL - Cancels all changes since pressing the SETUP/EXIT key except the darkness and tear-off settings (if they were changed).

νLOAD DEFAULTS - Loads factory defaults. The factory defaults are shown on the following pages.

NOTE: Loading factory defaults will require printer calibration.

νLOAD LAST SAVE - Loads values from the last permanent save.

Brady X-PLUSSeries User’s Guide

45