Problem | Solution | |
The ribbon is not loaded correctly. | Load the ribbon correctly. See “Ribbon Loading” on | |
page 39. | ||
| ||
|
| |
The darkness setting is incorrect. | Set the darkness to the lowest possible setting for | |
good print quality. See “Darkness” on page 46. | ||
| ||
|
| |
| Set the pressure to the minimum required for good | |
Incorrect printhead pressure or balance. | print quality. See “Printhead Pressure Adjustment” on | |
| page 73. | |
|
| |
The media is not feeding correctly. It is | Make sure that the media guide and media supply | |
“walking” from side to side. | guide touch the edge of the media. | |
|
|
A label format was sent to the printer but not recognized. The DATA light does not flash.
Problem | Solution | |
| Check the printer driver or software communications | |
| settings (if applicable). | |
|
| |
| Check the printer host port setting via the front panel | |
| (see page 53). Select the port that matches the one | |
| being used by the host. | |
The communication parameters are |
| |
Are you using the correct communication cable? See | ||
incorrect. | ||
page 22 for the requirements. | ||
| ||
|
| |
| Via the front panel, check the protocol setting. It | |
| should be set to “none.” See page 54. | |
|
| |
| Ensure that the correct driver is being used, if | |
| applicable. | |
|
|
Brady | 79 |