Braun 855RH, 604XD, 604XC, 604XB, 603E, 603A, 604XA, 603B Outboard Roll Stop Manual Operation, Turn

Manual Operating Instructions

To Manually Move Platform Inward (Retract) To Stow Position:

Read Platform Carriage Assem- bly Drive Chain Reengagement Procedure section on page 16!

1.Position (raise or lower) platform to stow level (height) using procedures outlined on pages 17 and 18.

2.Pull “T” handle release cable. See Figure 1.

3.Turn “T” handle to lock plat- form in the released position. See Figure 1.

4.Carefully push platform inward to stow position.

5.Reengage the release cable mechanism by a. turning the “T” handle and b. pushing the the “T” handle in fully (see Figure 2). Grasp the outer roll stop and move the platform in and out until the platform locks. You will feel the release mechanism engage.

3

2					TURN
						TO
					LOCK
				WA
						RN
								IN
									G
	Push T-
	manuallyand handle					in
	lock	out						fully and
			tomove
	Failurebeforeengageplatform									in
	result		to		lockdriving
			in
	platformdeployment.							platform
						platform				may
	result in unintended
								vehicle.
	and/or			seriousUnintendedent
				deploym					platform
			property						may
Figure 1		Do					bodily
				not			damage.injury
						remove!					81823

a

b						TURN
							TO
						LO
							CK
				WA
							RN
								IN
									G
	Push T-
	manuallyand handle						in
	lock	out			m			fully and
				to		ove
	Failurebeforeengageplatform									in
	result		to		lockdriving
			in
	platformdeployment.							platform
							platform			may
	result in unintended
								vehicle.
				seriousdeploymentUnintended
	and/or		property						platform
									may
Figure 2		Do						bodily
				not				damage.injury
							remove!				81823

WARNING

Push T-handle in fully and manually move platform in and out to engage platform lock before driving vehicle. Failure to lock platform may result in unintended platform deployment. Unintended platform deployment may result in serious bodily injury

and/or property damage.

Outboard Roll Stop Manual Operation

The automatic outboard roll stop is powered by an electric actuator. In the event of power or equip- ment failure, refer to the following instructions to manually operate the roll stop.

Note: The lift will not raise from ground level if the roll stop actuator detent pin has not been rein- stalled. The detent pin fully engages and activates the roll stop down switch.

Detent Pin Hairpin Cotter

CAUTION

Push roll stop down switch inward when inserting detent pin. Failure to do so will result in switch break- age.

Caution: Push the roll stop down switch inward (toward vehicle) before inserting the detent pin. Details on following page.

Failure to do so will result in switch damage.

Roll Stop

Roll Stop Actuator	Roll Stop Down Switch
	Page 19