Braun 604XC, 604XD, 604XB, 855RH, 603E, 603A, 604XA, 603B owner manual Fully-Folded Up-vertical

Pre-Lift Operation Notes

platform raises. Note: The lift platform will not raise if the roll stop is not in the UP position.

This is a built-in safety feature.

The LIFT DOWN function lowers the platform to ground level. The outboard roll stop automatically unfolds to ramp (horizontal) position when the platform contacts the ground to allow the wheelchair passenger on or off of the lift. The roll stop must be

fully unfolded before the front and rear wheelchair wheels (or standee) have crossed the roll stop.

Although the outboard roll stop is lift-powered and fully-automatic in operation, mechanical failures are possible. Discontinue lift operation immediately if the roll stop does not operate properly.

WARNING

Discontinue lift use immediately if any lift component does not operate properly. Failure to do so may result in serious bodily injury and/or property damage.

Fully-Folded (Up-vertical)

Outboard Roll Stop

Fully-Unfolded (Ramp position)

Outboard

Roll Stop

Outboard

Roll Stop

Electric

Actuator

Bridge Plate (Inboard Roll Stop): UVL lift models may be equipped with an automatic or manually operated bridge plate (except model UVL603A). The bridge plate bridges the gap between the lift platform and the vehicle floor as well as serving as an inboard roll stop.

Automatic Bridge Plate: Auto- matic bridge plates are spring-

loaded to raise to vertical position when the platform extends from the stow position. The automatic bridge plate folds down onto the vehicle floor as the platform raises to floor level. The bridge plate automatically folds down to the platform surface during the lift stow function. Discontinue lift operation immediately if the automatic bridge plate does not operate properly.

Manual Bridge Plates: Manual bridge plates are attendant operated. The bridge plate rests on the platform surface when the lift is in the stowed position. When the platform is fully- extended, the bridge plate is manually raised to the vertical position. When the platform is raised to floor level, the bridge plate is manually lowered to the vehicle floor (bridging position).

Vehicle Floor

Platform Below

Floor Level

Automatic

Bridge Plate (Inboard Roll Stop)

Floor Level

(Bridging Position)

Vertical Position

Vehicle Floor

Platform at Floor Level

Page 8