Braun 604XD, 604XC, 604XB, 855RH, 603E, 603A, 604XA Lift Control Switches, Control Switch Functions

Lift Operating Instructions

Lift Control Switches:

The UVL® logic control system provides fully auto- matic operation of all lift functions as well as op- tional automatic door operators (if so equipped). Lift functions can be performed from any position the platform happens to be in at the time the switch button is pushed.

There are two types of hand controls available for the UVL - the standard hand-held control switchbox, or the optional remote control. Both types of controls are equipped with four push-button switches. The functions activated by both types of controls are the same. The switch functions are labeled. The function of each switch is described below.

Remote Control Note: The effective range of the remote control is 20 feet. A range further than 20 feet does not allow an attendant to observe and assist the lift passenger.

LIFT	UP	DOWN
UP
LIFT
DOWN
	STOW	DOOR
		CLOSE
STOW
LIFT
DOOR
CLOSE
	THE BRAUN
	CORPORATION
81812
		86478
Hand-held Switchbox	Optional Remote
(Standard Equipment)	Control Transmitter

Control Switch Functions:

UP: From the stowed position, the LIFT UP function deploys (extends) the platform fully. The platform then raises to floor level height and moves inward to the vehicle floor level position (if applicable). Note: When the lift is in the stowed position, power doors automatically open when the UP switch is pressed (if so equipped).

From ground level, the LIFT UP function will first automatically raise (rotate) the outboard roll stop to the upright (vertical) position. Note: The lift will not raise if the roll stop is not in the UP position (built-in

Note: The lift will not stow with weight on the platform (built-in safety feature).

Fold handrails down before stowing lift. Failure to do so may result in serious bodily injury and/or property damage.

WARNING

Fold handrails down before stowing lift. Failure to do so may result in serious bodily injury and/or property damage.

safety feature). The platform then raises to floor level height and moves inward to the vehicle floor level position. Note: UVL600 and UVL600X lift models move inward to floor level position with an “arcing” motion. UVL850 Series lift models do not.

DOWN: The LIFT DOWN function lowers the platform to ground level (regardless of the position of the platform) and then unfolds the outboard roll stop to the ramp (horizontal) position. From the stowed position, the lift will extend and then lower. Note: When the lift is in the stowed position, power doors automatically open when the DOWN switch is pressed (if so equipped).

STOW: The STOW LIFT function raises or lowers the platform to stow level and then moves the platform inward (retracts) to the stow position.

DOOR CLOSE: When the vehicle is equipped with automatic door openers (optional), the DOOR CLOSE switch closes the doors. This function operates only when the platform is stowed or fully extended and below stow level.

Note: If any of these functions do not occur as described, discontinue lift use immediately and contact your sales representative or call The Braun Corporation at 1-800-THE LIFT. One of our national service representatives will direct you to an autho- rized service repairman who will inspect your lift.

In event of power or equipment failure, refer to Manual Operating Instructions to manually operate (stow) the lift, then contact your sales representative for further instructions.

Page 11