81823

Manual Operating Instructions

Hand Pump Handle

A

Hand

Pump

Release

Valve

approximate 1/16" intervals

maximum 30 inch lbs

minimum 15 inch lbs

seats

(stops)

N

C

L

E

O

P

S

O

E

 

Release Valve

Valve Tightening Specification:

Once valve seats (stops), tighten 15 to 30 inch pounds as shown.

b

a

TU

 

RN

 

TO

 

LOCK

To Manually Raise Platform

To Floor Level:

Note: Disregard procedures for manually moving the platform in or out if not applicable.

1.Remove pump handle from clips on side of power pack (or other storage location).

2.Place handle through pump cover access slot and into hand pump. Stroke hand pump until platform reaches floor height (see Photo C).

3.a. Pull “T” handle release cable

outward and b. turn “T” handle to lock platform into the re- leased position (see Figure 1).

4.Push platform in until it meets

floor of vehicle (if applicable).

5.Reengage the release cable mechanism by a. turning the “T” handle and b. pushing the “T” handle in fully (see Figure 2).

Note: Grasp the outer roll stop and move the platform in and out until the platform locks. You will feel the release mecha- nism engage. Read Platform

Carriage Assembly Drive Chain Reengagement Proce- dure section on opposite page!

b

B

Open

Close

(Down)

(Up/Stop)

Hand Pump Handle

C

a

TURN

TO

LOCK

 

 

 

 

WA

 

 

 

 

 

 

 

 

 

 

RN

 

 

 

 

 

 

 

 

 

IN

 

 

 

 

 

 

 

 

 

G

 

 

Push T-

 

 

 

 

 

 

 

manuallyand handle

in

 

 

 

 

 

lock

out

 

fully and

 

 

 

tomove

 

Failurebeforeengageplatform

in

 

result

to

 

 

 

 

 

 

in

lockdriving

 

 

 

 

platformdeployment.

 

platform

 

platform

may

 

result in unintended

 

 

 

 

 

 

 

vehicle.

 

 

 

 

seriousdeploymentUnintended

 

 

and/or

property

 

platform

 

 

 

 

may

 

Figure 1

 

Do

 

 

bodily

 

 

 

not

 

damage.injury

 

 

 

remove!

81823

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WA

 

 

 

 

 

 

 

 

 

 

RNIN

 

 

 

 

 

 

 

 

 

G

 

Push T-

 

 

 

 

 

 

 

manuallyand handle

in

 

 

 

 

 

lock

out

 

fully and

 

 

 

tomove

 

Failurebeforeengageplatform

in

 

result

to

 

 

 

 

 

 

 

in

lockdriving

platform

 

deploym

 

 

 

 

result in unintended

 

may

 

platforment.

 

 

vehicle.

 

platform

 

 

and/or

 

seriousdeploymentUnintended

 

property

 

 

platform

 

 

 

 

 

may

 

 

Do

 

 

bodily

 

Figure 2

 

not

 

damage.injury

 

 

 

remove!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 17

Page 19
Image 19
Braun 604XC, 604XD, 604XB, 855RH, 603E, 603A, 604XA, 603B owner manual To Manually Raise Platform To Floor Level, Release Valve