Briggs & Stratton 30236 General Recommendations, Generator Maintenance, Generator Cleaning

MAINTENANCE

GENERAL RECOMMENDATIONS

Regular maintenance will improve the performance and extend the life of the generator. See any authorized dealer for service.

The generator’s warranty does not cover items that have been subjected to operator abuse or negligence.To receive full value from the warranty, the operator must maintain generator as instructed in this manual.

Some adjustments will need to be made periodically to properly maintain your generator.

All service and adjustments should be made at least once each season. Follow the requirements in the “Maintenance Schedule” chart below in Figure 11.

NOTE: Once a year you should clean or replace the spark plug and replace the air filter. A new spark plug and clean air filter assure proper fuel-air mixture and help your engine run better and last longer.

GENERATOR

MAINTENANCE

Generator maintenance consists of keeping the unit clean and dry. Operate and store the unit in a clean dry

environment where it will not be exposed to excessive dust, dirt, moisture or any corrosive vapors. Cooling air slots in the generator must not become clogged with snow, leaves, or any other foreign material.

Check the cleanliness of the generator frequently and clean when dust, dirt, oil, moisture or other foreign substances are visible on its exterior surface.

NOTE: DO NOT use water or other liquids to clean generator. Liquids can enter the engine fuel system causing poor performance and / or failure to occur. In addition, if liquids enters the generator through cooling air slots, some of the liquid will be retained in voids and cracks of the rotor and stator winding insulation. Liquid and dirt buildup on the generator internal windings will eventually decrease the insulation resistance of these windings.

Generator Cleaning

Daily or before use, clean accumulated debris from generator. Keep linkage, spring and controls clean. Keep area around and behind muffler free from any combustible debris.

Generator parts should be kept clean to reduce the risk of overheating and ignition of accumulated debris.

•Use a damp cloth to wipe exterior surfaces clean.

•Use a soft bristle brush to loosen caked on dirt, oil, etc.

•Use a vacuum cleaner to pick up loose dirt and debris.

Figure 11 – Maintenance Schedule

FILL IN DATES AS YOU		SERVICE DATES
COMPLETE REGULAR SERVICE
				SERVICE DATES
	Before	Every 25 Hours	Every 50 Hours
MAINTENANCE TASK				Every 100
	Each Use	or Yearly	or Yearly	Hours or Yearly
Check oil level	X
Clean debris	X
Service air cleaner		X²
Change engine oil			X¹
Service spark plug				X
Service spark arrester				X
Clean cooling system				X²

Prepare for storage

If unit is to remain idle for longer than 30 days.

¹Change oil after the first (5) operating hours and every 50 hours or every year, whichever occurs first, thereafter. Change sooner when operating under dirty or dusty conditions.

²Replace more often under dirty or dusty conditions.

15