Briggs & Stratton Generator owner manual Gaseous Fuel System

Briggs & Stratton Power Products Home Standby Generator

Installation, Start-Up and Owner’s Manual

THE GASEOUS FUEL SYSTEM

WARNING

Propane and Natural Gas are extremely flammable and explosive.

Fire or explosion can cause severe burns or death.

•LP gas is heavier than air and will settle in low areas.

•Natural gas is lighter than air and will collect in high areas.

•The slightest spark can ignite these fuels and cause an explosion.

The information provided below is to assist gaseous fuel system technicians in planning installations. In no way should this information be interpreted to conflict with applicable fuel gas codes. Consult with your local fuel supplier or Fire Marshall if questions or problems arise.

Consult with the Home Standby Generator owner(s) and convey any technical considerations that might affect their installation plans before applying these general guidelines.

The following general rules apply to gaseous fuel system piping:

•The piping should be of a material that conforms to federal and local codes, rigidly mounted and protected against vibration.

•Install flexible gaseous pipe (supplied) between the Home Standby Generator fuel inlet port and rigid piping.

CAUTION

The supplied flexible gaseous pipe is not to be installed underground or in contact with the ground.

•The entire flexible gaseous pipe must be visible for periodic inspection and must not be concealed within, contact, or run through any wall, floor, or partition.

•Piping must be of the correct size to maintain the required supply pressures and volume flow under varying conditions.

•Use an approved pipe sealant or joint compound on all threaded fittings to reduce the possibility of leakage.

•Installed piping must be properly purged and leak tested, in accordance with applicable codes and standards.

Consider the following factors when planning to install the fuel supply system:

The Home Standby Generator engine is fitted with a fuel mixer system that meets the specifications of the California Air Resources Board for “tamper-proof” dual fuel systems. The unit will run on natural gas or liquefied propane.

•A minimum of one manual shutoff valve should be placed in the fuel supply line and located outside the building to facilitate servicing the generator.

•Natural gas fuel supply pressure at the generator's fuel inlet port should be between 5 to 7 inches of water (in. W.C.) at full load. LP fuel supply pressure should be 11 to 14 inches of water (in.W.C.) at full load.

The Home Standby Generator unit has been

factory set to run on natural gas. If you need to change from natural gas to LP gas, the unit will need to be reconfigured, as described on page 18.

It is recommended that the fuel connection incorporate the following components:

•A manual fuel shut-off valve located in the interior of the building.

•A manual fuel shut-off valve located outside the building, just before the generator unit.

•The termination of hard piping should include a sediment trap.

•A manometer port should be provided.

12