Briggs & Stratton Generator owner manual Know Your Control Panel, Auto/Off/Manual

Briggs & Stratton Power Products Home Standby Generator

Installation, Start-Up and Owner’s Manual

KNOW YOUR CONTROL PANEL

Compare this Control Panel illustration with your generator to familiarize yourself with the location of these important controls:

15 Amp Fuse

Set Exercise Switch

Set Exercise

Auto/Off/Manual

Breaker

Circuit

15Amp Fuse

Circuit Breaker

AUTO/OFF/MANUAL

Switch

15 Amp Fuse — Protects the Home Standby Generator DC control circuits. If the fuse has melted open or was removed, the engine cannot crank or start. Replace the fuse using only an identical BUSS AGC 15A fuse.

AUTO/OFF/MANUAL Switch — This three-position switch is used as follows:

•“AUTO” position is the normal operating mode. If a utility power outage is sensed, the generator will start automatically.When utility power is restored, the generator will shut down, and is ready for the next utility power outage.

•“OFF” position turns off generator, prevents generator from starting and resets any faults.

•“MANUAL” position starts the generator. It is used for maintenance or diagnostic functions.

Circuit Breaker — Protects the system from over- current conditions and must be in the “On” position to supply power to the Transfer Switch.

Set Exercise Switch — Used to set the exercise cycle start time and day-of-the-week. Exercise cycle only occurs in AUTO mode.

7