Britax Boulevard manual 1Place child restraint forward facing on vehicle seat

Installation: Forward Facing

Lap/Shoulder Belt Installation

•Figure A illustrates a typical forward-facing lap/ shoulder-belt installation.

•Whennotinuse,alwaysstoreLATCHconnectors in storage slots.

1�Place child restraint forward facing on vehicle seat.

•Restraint must be in full upright position when installed in forward-facing mode with children over 33 pounds (15 kg.).

•Britax recommends use of Versa-Tether® to improve installation. Remove Versa- Tether from pouch and loosely attach to an approved tether-anchorage point (pg. 24).

2�Pull vehicle belt out, then thread it over LATCH bar and through the forward- facing belt path (fig. B).

3�Verify that vehicle belt is not twisted and is routed over LATCH bars, then buckle (fig. C).

4�Rotate lever downward to open forward-facing lock-off farthest from where vehicle belt will be buckled.

5�Remove slack from lap portion of vehicle belt.

6�Kneel on child restraint to push it into vehicle seat while pulling shoulder portion of vehicle belt tightly through lock-off (fig. D).

A

B

C

20