Installation: Versa-Tether®
Using the Versa-Tether
1� Consult your vehicle’s owner’s manual for approved tether-anchorage locations.
2� Locate the tether on rear of restraint and place up and over seat back while securing restraint.
3� Secure child restraint by a seat-belt or LATCH system.
4� Press and hold tilt-lock adjuster, then pull to fully extend tether strap into a "V" shape.
5� Locate hook on strap and loosely attach tether to an approved anchor point.
• See figure A for forward- facing installation.
• See figures B and C for rear-facing installation.
NOTE: Rear-facing installation may also require use of Tether Connector Strap, as described on page 25.
6� Pull Versa-Tether strap to remove all slack. Roll up excess webbing and store in tether pouch.
7� Verify there is tension in Versa-Tether strap and that child restraint is properly secured. The restraint is secure when it cannot be moved front-to-back or side-to-side more than 1 inch (2.5 cm.) at belt path. If restraint is not secure, repeat procedure or use an alternate seating location.
