Britax Boulevard manual Rear-Facing Tether Connector Strap

Installation: Versa-Tether®

NOTE:

• The rear-facing recline angle of the child restraint should be 30º-45º from vertical (not to exceed 45º from vertical) when car is parked on a level

• The rear-facing recline angle can be adjusted by placing a rolled towel or pool noodle crease of the vehicle seat, and restraint can be stabilized by tightening tether as shown in figure C, using anchor point 3.

• It may be necessary to loosen tether and vehicle seat belt before adjusting recline position.

Rear-Facing Tether Connector Strap

WARNING! Only use tether connector strap for rear-facing tether installation.

Because every vehicle model is different, sometimes you cannot find a location to properly anchor the tether, or the structural part of seat is too large

for the hook. Use rear-facing tether connector strap (fig. D) to assist in creating an anchor point.

1�Find a fixed vehicle seat belt anchor or vehicle seat leg (that is bolted to the floor) to which the strap can be wrapped around.

2�If you cannot find an acceptable location to create an anchor point, contact vehicle manufacturer to identify a suitable tether connection point.

3�Loop strap around metal anchor.

4�Take metal D-ring and thread it through webbing loop on other end of strap.

5�Pull metal D-ring all the way through until strap is tight around metal anchor.

6�Use D-ring as an attachment point for hook on tether strap.

25