Britax P321900 manual Lower Universal Anchorage System Luas Installation

Installation : Forward-Facing

Lower Universal Anchorage System (LUAS) Installation

• Figure A illustrates a typical		forward-facing	LUAS
	installation.
• Verify that your vehicle is		equipped with	LUAS
	anchors. If LUAS anchors are not available, you must
	use vehicle belt installation methods.
	WARNING!			A Forward-Facing
• This child seat must not be used forward-facing
	for children less than one year of age OR who weigh
	less than 9.1 kg (20 lbs).
•	This child seat must be in the upright position when
	installed forward-facing.
•	Always use the Versa-Tether when the child seat is
	installed forward-facing. Check your vehicle owner’s

manual for approved tether anchor locations. b

1Remove the LCS connectors from storage slots under the cover. See page 29. Pull both LCS connectors completely through the child seat’s right-side, rear-facing belt slot (Fig. B) so they are

on the outside of the shell.

NOTE: The child seat is assembled with LCS

2Press and hold one LCS adjuster release button, C

then pull to extend LCS strap to full length. Repeat on the other end of the strap.

3Thread the appropriate LCS connector through forward-facing belt path (Fig. C) at the back of the child seat.

4Place the child seat sideways in the upright position on the vehicle seat with the back of the child seat facing you.

5Remove the Versa-Tether from the pouch and place it up and over the child seat back.connectors in rear-facing mode.

18