![](/images/new-backgrounds/1245015/24501525x1.webp)
Installation:
Lap-Belt Installation
• Figure A illustrates a typical forward-facing, lap-belt installation.
• When not in use, always store the LATCH connectors in storage slots. See page 30.
WARNING! This child seat must not
less than one year of age OR weighing less than 20 pounds.
IMPORTANT: Britax recommends that the Versa- Tether® be used at all times. Using the tether will improve the stability of the child seat and reduce the B risk of injury. Check your vehicle owner’s manual for approved tether anchor locations.
1 Place the child seat
•Child seat may be in upright or recline position. See Recline Adjustment on page 30.
2 If the vehicle is equipped with an approved C tether anchor for the chosen seating position,
remove the
3 Pull the vehicle belt out and thread it through the forward- facing belt path (Fig. B).
4 Verify that the vehicle belt is not twisted and buckle (Fig. C).
5 Push the child seat firmly into vehicle seat while tightening the vehicle belt.
Installation:
6 If the vehicle is equipped with an approved tether anchor, attach the
7 Verify that the vehicle belt is tight, locked, and child seat is secure.
•The child seat is secure when it cannot be moved
Removal
•If connected, disconnect the
•Press the red release button on the vehicle belt buckle and pull the vehicle buckle from the child seat belt path.
22 | 23 |