Brocade Communications Systems RFS6000 Specifications

Brocade Mobility RFS6000 Controller Installation Guide 5

53-1001573-03

Chapter

2

Specifications

In this chapter

•Physical specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

•Power cord specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Physical specifications

Power cord specifications

A power cord is not supplied with the controller. Use only a correctly rated power

cord certified (as appropriate) for the country of operation.

Power protection

•If possible, use a circuit dedicated to data processing equipment. Commercial

electrical contractors are familiar with wiring for data processing equipment

and can help with the load balancing of these circuits.

•Install surge protection. Be sure to use a surge protection device between the

electricity source and the Mobility RFS6000 Controller.

Width 440mm (17.32 in)

Height 44.45mm (1.75 in)

Depth 390.8mm (15.38 in)

Weight 6.35 Kg (14.0 lbs)

Operating Temperature 0°C - 40°C

Operating Humidity 5% - 85% RH, non-condensing

Operating Altitude 3 km (10000 ft)

Contents

Main Brocade Communications Systems, Incorporated Document History 1 Introduction 1 2 Specifications 5 3 LED Codes 7 4 Hardware Setup 15 5 Regulatory Information 23 About This Document Audience Supported hardware and software Document conventions Notes, cautions, and warnings Contacting Brocade Customer Support Web Site Page Page Introduction Package contents Warnings Site preparation Page Specifications Physical specifications Power cord specifications Power protection Page LED Codes System status LEDs System Status 2 System Status 1 Fan status Temperature status Start up / POST (primary system or redundant system) System status LEDs 3 Controller status (primary system) Controller status (redundant system) System status 1 LED System status 2 LED Event System status LEDs Fan LED Temperature status LED Fan LED Event Temperature LED Event RJ-45 Gigabit Ethernet LEDs 3 RJ-45 Gigabit Ethernet LEDs RJ-45 port speed LED RJ-45 port status LED Port speed LED Event Port status LED Event SFP Gigabit Ethernet LEDs Out of band management port LEDs 3 Out of band management port LEDs Out of band management port speed LED Out of band management port status LED Port speed LED Event Port status LED Event Page Hardware Setup Cabling information Gigabit Ethernet on the Mobility RFS6000 Controller Installing Gigabit Ethernet SFPs Page Connecting USB devices Rack mount instructions Mobility RFS6000 Controller console port setup Supplying power to the Mobility RFS6000 Controller Verifying the installation Regulatory Information ! Country selection Laser devices - Gigabit Ethernet SFP option Radio frequency interference requirements - FCC Radio frequency interference requirements - Canada CE Marking and European Economic Area (EEA) Statement of compliance . Japan (VCCI) - voluntary control council for interference Class A ITE Waste Electrical and Electronic Equipment (WEEE)