Brocade Communications Systems RFS6000 Connecting USB devices

Connecting USB devices 4

Brocade Mobility RFS6000 Controller Installation Guide 19

53-1001573-03

Connecting USB devices

The Mobility RFS6000 Controller contains one USB port for connecting USB flash

storage devices to the controller. The controller can use the USB flash storage

device for file transfers and firmware updates. Follow the setup instructions below

to connect the devices to the controller and then access those devices through the

Web UI or Command Line Interface.

1. Connect the USB flash drive to the USB .

2. Wait a few seconds for the drive to be recognized by the controller.

3. Follow the instructions in the Brocade Mobility RFS Controller System

Reference Guide or Brocade Mobility RFS Controller CLI Reference for more

information on accessing USB storage devices from the controller for file

transfers or firmware updates..

NOTE

The controller supports USB flash devices formatted with FAT or VFAT (FAT32)

filesystems only. If your flash storage device is formatted with another filesystem you

will need to format

Contents

Main Brocade Communications Systems, Incorporated Document History 1 Introduction 1 2 Specifications 5 3 LED Codes 7 4 Hardware Setup 15 5 Regulatory Information 23 About This Document Audience Supported hardware and software Document conventions Notes, cautions, and warnings Contacting Brocade Customer Support Web Site Page Page Introduction Package contents Warnings Site preparation Page Specifications Physical specifications Power cord specifications Power protection Page LED Codes System status LEDs System Status 2 System Status 1 Fan status Temperature status Start up / POST (primary system or redundant system) System status LEDs 3 Controller status (primary system) Controller status (redundant system) System status 1 LED System status 2 LED Event System status LEDs Fan LED Temperature status LED Fan LED Event Temperature LED Event RJ-45 Gigabit Ethernet LEDs 3 RJ-45 Gigabit Ethernet LEDs RJ-45 port speed LED RJ-45 port status LED Port speed LED Event Port status LED Event SFP Gigabit Ethernet LEDs Out of band management port LEDs 3 Out of band management port LEDs Out of band management port speed LED Out of band management port status LED Port speed LED Event Port status LED Event Page Hardware Setup Cabling information Gigabit Ethernet on the Mobility RFS6000 Controller Installing Gigabit Ethernet SFPs Page Connecting USB devices Rack mount instructions Mobility RFS6000 Controller console port setup Supplying power to the Mobility RFS6000 Controller Verifying the installation Regulatory Information ! Country selection Laser devices - Gigabit Ethernet SFP option Radio frequency interference requirements - FCC Radio frequency interference requirements - Canada CE Marking and European Economic Area (EEA) Statement of compliance . Japan (VCCI) - voluntary control council for interference Class A ITE Waste Electrical and Electronic Equipment (WEEE)