HOW TO REMOVE BOBBIN CASE
1. Raise needle to its highest position.
2. Open the shuttle cover.
3. Pull and open the latch of bobbin case.
4. Pull out bobbin case from the shuttle.
HOW TO THREAD AND INSERT BOBBIN CASE
1.Unwind about 8 cm (3- inches) of thread from the bobbin. Insert wound bobbin into
4.Holding case latch with the metal finger of case pointing up, fit it into the notch at the top of the shuttle race.
2.Pull trailing thread into the slot case.
5.Release latch and push case to the right making sure the case is in the proper position. Close the Shuttle Cover.
3.Pull thread to the left under the tension spring until thread enters into delivery eye.
NOTE: The thread drawn out of the case is to be left hanging below the race. Leave about 15
