Sew-Light
To change the bulb:
1. Swing open face plate.
2. Remove bulb by turning counter- clockwise.
3. After replacement, close the face plate.
NOTE:
1. Make sure new bulb is the same specification as old one.
2. Make sure to switch off the light and pull out supply plug when you replace the bulb in order to avoid electric hazards.
Presser Foot
To remove the presser foot;
1.Raise needle to its highest position.
2.Raise presser foot.
3.Loosen presser foot thumb screw and remove presser foot.
4.To attach the presser foot, place grooved side of the foot against the flat of the presser bar.
5.Tighten thumb screw.