Brother PROGRAMMABLE ELECTRONIC PATTERN SEWER Using the Test switch Checking the sewing pattern

6. USING THE OPERATION PANEL

6-4. Using the TEST switch (Checking the sewing pattern)

Use the TEST switch to begin sewing again from any desired point when the thread breaks or the bobbin thread runs out.

1217S			1215S	1. Press the TEST switch (15). The indicator (16) will
				light.
				2. If the work clamp is raised, depress the work clamp
				lifter pedal (2) to lower the work clamp.
	(16)			3. Press the starting pedal (1).
				Note
				After the feed mechanism has returned to the
				home position, it will then move the sewing start
				position and the program number will stop
				flashing.
				This only occurs the first time that a program is
				selected.
		(17)
	(15)
				4. Press the starting pedal (1). (The needle will remain
				stationary as the work clamp advances through the
				pattern at low speed one stitch at a time. Press the
				presser lifter pedal (2) to fast forward.
				• If the STEP BACK switch (17) is pressed while moving
				at low speed when memory switch No. 20 is ON, the
				work clamp will move in the forward direction in steps
				of 100 stitches.
				5. When the work clamp reaches the desired position,
				press the TEST switch (15). The work clamp will stop,
				and the test indicator (16) will go out. If the work clamp
				was stopped too early, press theTEST switch (15)
				again to proceed.
				• If the work clamp was stopped too late, press the
				STEP BACK switch (17) to advance the work clamp
				one stitch at a time.
			1942S	Resuming operation from a stopping poing
				6. Sewing will start when the starting pedal (1) is
				pressed.

BAS-341F, 342F

20