Wireless configuration for Windows® using the Brother automatic installer application (For
m Wait until the Status LED of your machine indicates Connected. The Status LED will turn on for 5 minutes. (See the table below) This indication means the machine has successfully connected to your access point/router. You can now use your machine in a wireless network.
If the LED indicates Connection Fail (See the table below), the machine has not successfully connected to your access point/router. Try starting from j again. If the same message is indicated again, reset the print server back to its factory default settings. For resetting, see Reset the network settings to the factory default on page 118.
If the LED indicates No Access Point (See the table below), the machine has detected no access | 4 |
point/router on your network. Make sure you place the Brother machine as close to the network access point/router as possible with minimal obstructions, and try starting from j again. If the same message is indicated again, reset the print server back to its factory default settings and try again. For resetting, see Reset the network settings to the factory default on page 118.
If the LED indicates Connection Error (See the table below), the machine has detected more than 2 access points/routers on your network that have the SecureEasySetup™, the
LED indications when using the
| Setting | Connecting |
| Connection | No Access |
| |
LEDs | SES/WPS/ | Connected 2 | Connection Error 4 | ||||
WLAN 1 | Fail 3 | Point 3 | |||||
| AOSS 1 |
|
| ||||
|
|
|
|
|
| ||
Back |
|
|
|
|
|
| |
Cover |
|
|
|
|
|
| |
Toner |
|
|
|
|
|
|
(Yellow)
Drum
(Yellow)
Paper
(Yellow)
Status
(Red /
Green)
1The LED will blink (turn on for 0.2 seconds and off for 0.1 second).
2The LED will turn on for 5 minutes.
3The LED will blink (turn on for 0.1 second and off for 0.1 second) for 30 seconds.
4The LED will flash 10 times and then turn OFF for half a second. This pattern will repeat 20 times.
44