Wireless Configuration for Macintosh using the Brother installer application (For HL-5370DW)

j Press the wireless setup button located at the back of the machine for less than 2 seconds as shown in the illustration below. This will put the machine in one-push wireless setting mode. This feature will automatically detect which mode your access point uses for one-push configuration (SecureEasySetup™, Wi-Fi Protected Setup or AOSS™).

5

Note

•Make sure that the label covering the USB interface connector is removed.

•Use a pointy object such as a ballpoint pen to press the button.

•If you press the button for 3 seconds or more, the machine will change to the PIN Method of the Wi-Fi Protected Setup mode. See How to configure your wireless machine, using the PIN Method of Wi-Fi Protected Setup on page 100.

k The machine starts the one-push wireless setting mode.

The machine will search for an access point that supports SecureEasySetup™, Wi-Fi Protected Setup or AOSS™ for 2 minutes.

l Put your access point in the SecureEasySetup™ mode, Wi-Fi Protected Setup mode or AOSS™ mode, depending on what is supported by your access point. Please refer to the instruction manual that came with your access point.

74