STEP 2 Installing the Driver & Software

Macintosh®

3For USB Interface Users

(For Mac OS® X 10.2.4 or greater)

Macintosh® USB

Important

3 Carefully route the USB cable through the

trench and out the back of the machine as

Make sure that you have finished the

shown below and connect the cable to your

instructions from STEP 1 Setting Up the

Macintosh®.

Machine on pages 4 through 14.

 

Note

• For Mac OS® X 10.2.0 to 10.2.3 users, upgrade to Mac OS® X 10.2.4 or greater. (For the latest information for Mac OS® X, visit http://solutions.brother.com)

• Make sure there are no memory cards or a USB Flash memory drive inserted into the media drives or USB direct interface at the front of the machine.

1 Using both hands, use the plastic tabs on both sides of the machine to lift the scanner cover until it locks securely into the open position.

Improper Setup

• DO NOT connect the machine to a USB port on a keyboard or a non-powered USB hub. Brother recommends that you connect the

machine directly to your Macintosh®.

• Make sure that the cable does not restrict the cover from closing, or an error may occur.

• Make sure you use a USB 2.0 cable that is no longer than 6 feet (2 meters) long.

2

 

4

Lift the scanner cover to release the lock .

Insert the USB cable into the USB socket

Gently push the scanner cover support

 

marked with a

symbol. You will find the

down and close the scanner cover .

USB socket inside the machine on the right as shown below.

26