Installing the Driver & Software

Macintosh®

4For Network Interface Users (For Mac OS® X 10.2.4 or greater)

Important

Make sure that you have finished the instructions from STEP 1 Setting Up the Machine on pages 4 through 14.

Note

•For Mac OS® X 10.2.0 to 10.2.3 users, upgrade to Mac OS® X 10.2.4 or greater. (For the latest information for Mac OS® X, visit http://solutions.brother.com)

•Make sure there are no memory cards or a USB Flash memory drive inserted into the media drives or USB direct interface at the front of the machine.

3 Carefully route the network cable through the trench and out the back of the machine.Then, connect the cable to your network.

Improper Setup

Make sure that the cable does not restrict the cover from closing, or an error may occur.

1 Using both hands, use the plastic tabs on both sides of the machine to lift the scanner cover until it locks securely into the open position.

Note

If both USB and LAN cables are being used, guide both cables through the trench with one on top of the other.

4 Lift the scanner cover to release the lock . Gently push the scanner cover support down and close the scanner cover .

Macintosh® Network

2 Insert the network cable into the LAN socket

marked with a symbol. You will find the LAN socket inside the machine on the left as shown below.

5 Turn on the machine by connecting the power cord.

6 Turn on your Macintosh®.

29