104
PhotoCapture Center® Difficulties
Difficulty Suggestions
Removable Disk does not work
properly. 1 Have you installed the Windows® 2000 update? If not, do the following:
1) Un plug the USB cable.
2) Install the Windows® 2000 update, and see the Quick Setup Guide. After
the installation the PC will be automatically restarted.
3) Wait about 1 minute aft er you restart the PC, and then conn ect the USB
cable.
2 Take out th e media card and p ut it back in again.
3 If you have tried ‘Eject’ from within Windows®, take out the media card before
you continue.
4 If an error message appears when you try to eject the media card, it means
the card is being accessed. Wait a while and then try again.
5 If all of the above do not work, turn off your PC and machine, and then turn
them on again. (You will have to unplug the power cord of the machine to turn
it off.)
Cannot access Removable Disk
from Desktop icon.
Make sure you have put the media card into the media slot.
Network Difficulties
Difficulty Suggestions
Cannot print over the N etwork. Make su re that your machi ne is powered on an d is online and in R eady mode.
Print a Network Config uration lis t (see Reports on page 62.) an d check the current
Network settings printed in this list. Reconnect the LAN cable to the hub to verify
that the cabling and ne twork connections are good. If poss ible, try connect ing the
machine to a different por t on your hub using a dif ferent cable. If the co nnections
are good, the machine shows LAN Active for 2 seconds.
(If you are having Network problems, see the Network User’s Guide on the
CD-ROM for more information.)
The network scanning feature does
not work. (For Windows® users only) Firewall setting on your PC may be rejecting the
necessary network connection. Follow the instructions below to configure the
Firewall. If you are using a personal Firewall software, see the User’s Guide for
your software or contact the software manufacturer.
<Windows® XP SP2 users >
1Click the Start button, Settings, ControlPanel and then WindowsFirewall.
Make sure that Window s Firewall on the Ba sic tab is set to On.
2Click the Exceptions tab and Add port butto n.
3 Enter any name, port number (54295 for network scanning and 54926 for
Network PC-Fax receiving), choose UDP and click OK.
4 Make sure if the new setting is added and is checked, and then click OK.
For Windows® XP SP1 user’s, please visit the Brother Solutions Center.
The network PC-Fax Receive
feature does not work.