Configuring your machine for a wireless network

One push configuration using Wi-Fi Protected Setup or AOSS™

You can use WPS or AOSS™ from the control panel menu to configure your wireless network settings if your WLAN access point/router (A) supports either Wi-Fi Protected Setup (PBC 1) or AOSS™.

3

1Push Button Configuration

IMPORTANT

•If you are going to connect your Brother machine to your network, we recommend that you contact your system administrator prior to installation. You must know your wireless network settings before you proceed with this installation.

•If you have previously configured the wireless settings of the machine, you must reset the LAN settings before you can configure the wireless settings again.

To reset the LAN settings, see Restoring the network settings to factory default uu page 41.

One-push configuration using WPS (Wi-Fi Protected Setup) or AOSS™

For MFC-J425W/J430W/J432W/J435W

a Press Menu.

b Press a or b to choose Network. Press OK.

c Press a or b to choose WPS/AOSS. Press OK.

d When Enable WLAN? is displayed, press OK to accept. This will start the wireless setup wizard.

To cancel, press Stop/Exit.

17