Configuring your machine for a wireless network

g Using a computer that is on the network, type “http://access point’s IP address/” into your browser. (Where “access point’s IP address” is the IP address of the device that is used as the Registrar 1.) Go to the WPS (Wi-Fi Protected Setup) setting page and input the PIN which the LCD shows in f to the Registrar and follow the on-screen instructions.

1The Registrar is normally the WLAN access point/router.

Note

 

3

 

The setting page is different, depending on the brand of WLAN access point/router. See the instruction

 

manual that came with your WLAN access point/router.

 

 

 

 

If you are using your Windows Vista® or Windows® 7 computer as a Registrar, perform the following instructions.

Note

To use a Windows Vista® or Windows® 7 computer as a Registrar, you need to register it to your network in advance. See the instruction manual that came with your WLAN access point/router.

1(Windows Vista®)

Click , Network, and then Add a wireless device. (Windows® 7)

Click , Control Panel, Network and Internet, and then

Add a wireless device to the network.

2Choose your machine and click Next.

3Input the PIN from the printed page and then click Next.

4Choose your network that you want to connect to, and then click Next.

5Click Close.

h A connection result message appears for 60 seconds on the LCD and a wireless LAN report will

automatically be printed. If the connection failed, check the error code on the printed report. uuQuick Setup Guide: Troubleshooting

(Windows®)

You have completed the wireless network setup. If you would like to continue installing drivers and software necessary for operating your device, please choose Install MFL-Pro Suite or Initial Installation/Install MFL-Pro Suite from the CD-ROM menu.

(Macintosh)

You have completed the wireless network setup. If you would like to continue installing drivers and software necessary for operating your device, please double-click Start Here OSX in the CD-ROM.

22