Configuring your machine for a wireless network

Note

Routers or access points that support Wi-Fi Protected Setup have a symbol as shown below.

3

For MFC-J425W/J430W/J432W/J435W

a Press Menu.

b Press a or b to choose Network. Press OK.

c Press a or b to choose WPS w/PIN Code. Press OK.

d When Enable WLAN? is displayed, press OK to accept. This will start the wireless setup wizard.

To cancel, press Stop/Exit.

e The LCD will show an 8 digit PIN and the machine begins searching for a WLAN access point/router for up to 5 minutes.

f Using a computer that is on the network, type “http://access point’s IP address/” into your browser. (Where “access point’s IP address” is the IP address of the device that is used as the Registrar 1.) Go to the WPS (Wi-Fi Protected Setup) setting page and input the PIN which the LCD shows in e to the Registrar and follow the on-screen instructions.

1The Registrar is normally the WLAN access point/router.

Note

The setting page is different, depending on the brand of WLAN access point/router. See the instruction manual that came with your WLAN access point/router.

If you are using your Windows Vista® or Windows® 7 computer as a Registrar, perform the following instructions.

Note

To use a Windows Vista® or Windows® 7 computer as a Registrar, you need to register it to your network in advance. See the instruction manual that came with your WLAN access point/router.

20