4Print the Network configuration page of the NC-2200w and check if the settings such as wireless and IP address settings are correct for your network. The problem may be the result of mismatched wireless setting, or mismatched or duplicate IP address. Verify that the Wireless settings and the IP address are correctly loaded into the NC-2200w. And make sure that no other nodes on the network have this IP address.
5Try pinging the NC-2200w from the host operating system command prompt with the command:
ping ipaddress
Where the ipaddress is the NC-2200w IP address (note that in some instances it can take up to a few minutes for the NC- 2200w to load its IP address after setting the IP address or powered on).
6If you have tried 4 or 5 above and it does not work, then reset the NC-2200w back to the default setting and try from the initial setup again. For the information how to reset to the factory default setting see Test Button on page 1-4.
7Check if a personal firewall such as ICF for Windows® XP is running on your computer. If it is running, temporarily turn it off and try again.