Brother NX 600 operation manual Pass the thread under the thread guide plate from the right

GETTING READY ————————————————————————————————————————————

CAUTION

●If the spool or the spool cap is not positioned correctly, the thread may become tangled around the spool pin or the needle may break.

●Three spool cap sizes are available (large, medium and small), allowing you to choose a spool cap that best fits the size of spool being used. If the spool cap is too small for the spool being used, the thread may catch on the slit in the spool or the needle may break.

hWhile holding the spool with your right hand, pull the thread with your left hand, and then pass the thread behind the thread guide cover to the front.

1

a Thread guide cover

iPass the thread under the thread guide plate from the right.

1

aThread guide plate

jPull the thread to the right, pass it under the hook on the thread guide for bobbin winding, and then wind it counterclockwise between the discs.

1

1

aThread guide for bobbin winding

kWhile using your left hand to hold the end of the thread that wraps around the thread guide for bobbin winding, use your right hand to wind the free end of the thread clockwise around the bobbin four or five times.

lPull the thread to the right and pass it through the slit in the bobbin winder seat.

1

aSlit in bobbin winder seat (with built-in cutter)

XThe thread is cut to a suitable length.

CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

20