Brother NX 600 operation manual Pass the thread under the thread guide plate from the right

GETTING READY ————————————————————————————————————————————

CAUTION

●If the spool or the spool cap is not positioned correctly, the thread may become tangled around the spool pin or the needle may break.

●Three spool cap sizes are available (large, medium and small), allowing you to choose a spool cap that best fits the size of spool being used. If the spool cap is too small for the spool being used, the thread may catch on the slit in the spool or the needle may break.

hWhile holding the spool with your right hand, pull the thread with your left hand, and then pass the thread behind the thread guide cover to the front.

1

a Thread guide cover

iPass the thread under the thread guide plate from the right.

1

aThread guide plate

jWhile using your right hand to hold the thread passed under the thread guide plate taut, pass

the thread through the guides in the order (up → left → down → up → down) shown.

1

aShutter

The following diagram shows the shutter position when the presser foot is lowered. Since the shutter is closed when the presser foot is lowered, the machine cannot be threaded. Be sure to raise the presser foot so that the shutter is open in order to thread the machine.

1

aShutter

kPass the thread through the thread hook at the base of the needle bar.

1

aNeedle bar thread hook

Next, use the needle threader to thread the needle. Continue with the procedure in "Threading the needle" (on the next page).

CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

26