Brother NX 600 operation manual Eyelet Stitching, Eyelet stitch, AAttach monogramming foot N

UTILITY STITCHES ———————————————————————————————————————————

Eyelet Stitching

Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm (1/4, 15/64 and 3/16 inch).

			Stitch Width		Stitch Length		Presser
Stitch Name	Pattern	Application	[mm (inch.)]		[mm (inch.)]
							Foot
			Auto	Manual	Auto	Manual
	56	Sewing eyelets, for example, on		7.0, 6.0 or		7.0, 6.0 or
Eyelet stitch			7.0	5.0	7.0	5.0	N
		belts	(1/4)	(1/4, 15/64	(1/4)	(1/4, 15/64
				or 3/16)		or 3/16)

CONTENTS GETTING

aAttach monogramming foot "N".

•For details, refer to "Replacing the presser foot" (page 37).

bSelect stitch 56 .

•For details, refer to "Selecting stitching" (page 66).

cAdjust either the stitch width or the stitch length to select the desired eyelet size.

7 mm 6 mm 5 mm (1/4 inch)(15/64 inch) (3/16 inch)

•For details, refer to "Adjusting the Stitch Width and Length" (page 55).

dLower the needle into the fabric at the beginning of the stitching, and then lower the presser foot lever.

eStart sewing.

XOnce sewing is completed, the machine automatically sews reinforcement stitches, then stops.

fUse the eyelet punch to cut a hole in the center of the eyelet.

•When using the eyelet punch, place thick paper or some other protective sheet under the fabric before punching the hole in the fabric.

Memo

zIf thin thread is used, the stitching may be open. If this occurs, sew the eyelet twice before removing the fabric, one on top of the other.

READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

104