When the device sends data to the printer, it may send both an LF and a CR command at the end of a line in order to move the print head to the left margin (via the CR command) of the next line (via the LF command). However, some devices send only one command, and in these cases, the printer must respond as if both commands were sent. If your device sends only LF or CR commands at the ends of lines, select [LF=CR+LF CR=CR+LF].

5Paper Sensor Threshold

Available settings: Setting a number (0 - 255)

Default setting: [128]

This parameter determines the threshold of the paper detection sensor.

6Wireless I/O (PJ-662/663 only) Available settings: [Bluetooth], [IrDA] Default setting: [Bluetooth]

This parameter determines whether a Bluetooth connection or an IrDA connection can be used.

7Wireless Switching Mode (PJ-662/663 only) Available settings: [Disable], [Enable] Default setting: [Disable]

This parameter determines whether the buttons on the printer can be used to switch between Bluetooth connection and IrDA connection modes (see Switching Between IrDA and Bluetooth (PJ-662/663 Only)

on page 15).

PJ-600 Series Utility

3

35