67
CUTTER
ERROR!
This message appears if the tape cut-
ter is closed when you try to print or
feed the tape.
Turn the P-touch off, then on
again.
EEPROM
ERROR!
This message appears if a checksum
error occurred when the P-touch was
turned on or if the keyword was dam-
aged and it failed to initialize.
Contact your service representa-
tive.
INTERFACE
ERROR!
This message appears if an error
occurs while data is being sent from
the computer to the P-touch.
Cancel the print job, and then
try printing again.
INVAL.
CHRS!
This message appears if the cursor is
not below a number when you hold
down c and press O.
Move the cursor below a
number before holding down
c and pressing O.
LENGTH
LIMIT!
• This message appears if the text is
longer than 3’ 3 1/3” (1 meter) when
you try to print.
• Shorten the text to less than 3’
3 1/3” (1 meter) before trying
to print.
• This message appears if the Length
function is used to set a label
length that is less than 1.6” (4.0
cm) or more than 11.8” (30.0 cm).
• Set the label length between
1.6” (4.0 cm) and 11.8” (30.0
cm).
• This message appears if the Tab
Length function is used to set a tab
length that is more than 11.8”
(30.0 cm).
• Set the tab length so that it is
less than 11.8” (30.0 cm).
LINE
LIMIT!
This message appears if the number
of lines in the text is greater than the
maximum number of lines possible
for the installed tape.
Reduce the number of lines or
install a tape of greater width.
MEMORY
FULL!
This message appears if you try to
store a text file after the maximum
number of characters has already
been stored in the memory.
Delete an unwanted file to make
room for the new one.
NO
FILES!
This message appears if you try to
recall or delete a text file from the
memory when none are stored.
Store a text file first.
Error Message Cause Remedy