S-7200C
10. ADJUSTMENTS
115
１０. ADJUSTMENTS
CAUTION
Maintenance and inspection of the sewing machine
should only be carried out by a qualified technician.
Ask your Brother dealer or a qualified electrician to
carry out any maintenance and inspection of the
electrical system.
If any safety devices have been removed, be
absolutely sure to re-install them to their original
positions and check that they operate correctly
before using the machine.
Secure the table so that it will not move when tilting
back the machine head. If the table moves, it may
crush your feet or cause other injuries.
Use both hands to hold the machine head when
tilting it back or returning it to its original position. If
only one hand is used, the weight of the machine
head may cause your hand to slip, and your hand
may get caught.
Turn off the power switch and disconnect the power
cord from the wall outlet at the following times,
otherwise the machine may operate if the treadle is
depressed by mistake, which could result in injury.
・ When carrying out inspection, adjustment and
maintenance
・ When replacing consumable parts such as the
rotary hook and knife
If the power switch needs to be left on when carrying
out some adjustment, be extremely careful to
observe all safety precautions.
１０-１. Adjusting the actuator switch position
The installation position for the actuator switch (1) can be
adjusted to <A> or <B>.
Adjust so that it is in a position where it is easy to operate.
1. Remove the two screws (2).
2. Move the switch setting base (3) to move the actuator
switch (1) to the preferred position <A> or <B>.
3. Tighten the two screws (2).
* If using the thread wiper, use it at position <A>.
If the thread wiper is used at position <B>, it may obstruct
the actuator switch (1) when it operates.
< Actuator switch rotation function >
Additionally, the actuator switch (1) can be rotated 90
degrees as shown in the illustration. Select the position that
is easier to use.
4247M 4248M
Back
4246M